Cadence Acoustics Phoenix 2400 Watt Class D Mono Block Amplifier

Cadence Acoustics Phoenix 2400 Watt Class D Mono Block Amplifier Review

Cadence Acoustics Phoenix 2400 Watt Class D Mono Block Amplifier Feature

• Cadence Phoenix class D mono block amplifier
• 800W @ 4 ohm RMS; 1200W @ 2 ohm RMS; 2400W @ 4 ohm twin amp bridged RMS
• Frequency Response: 10Hz - 500Hz
• Minimum THD: <0.01%; S/N Ratio: >100dB; Damping Factor: >220 @ 100Hz
• Dimensions (L x W x H): 20" x 7.25" x 2.25"

The Cadence Phoenix is a class D mono block amplifier. It has a high speed MOSFET power supply and studio-grade bipolar output stage transistors. With fully adjustable 12dB per octave crossovers, the low pass crossover has a range of 50Hz - 150Hz. For an extra boost in bass, there is an adjustable 18dB Bass EQ Boost Control. All class D United amplifiers have a fully adjustable subsonic filter of 10Hz - 50Hz along with an adjustable 7dB subsonic boost control. Also on the class D mono blocks is a phase control switch for 0 Degree or 180 Degree and a master / slave switch allowing one to daisy chain the amplifiers of the same model for double the power. All United Series amplifiers have a mute and delay soft start system and a full IC-controlled protection circuitry. There is an 8 volt preamp circuitry along with RCA preamp line outputs. A dashboard bass remote control is standard on all models.At 4 ohms RMS, the Phoenix has a power handling of 800 Watts. At 2 ohm RMS, the power handling is 1200 Watts. At 4 ohm twin amp bridged, the power handling is 2400 Watts. It has a frequency response of 10Hz - 500Hz. The minimum harmonic distortion of the Phoenix is <0.01%, the signal-to-noise ratio is >100dB, and the damping factor is >220 @ 100Hz. The dimensions are 20" (L) x 7.25" (W) x 2.25" (H).This product is covered by a two (2) year warranty.